Connection Instructions
-
Connect the HAND-TRAK cable into the appropriate interface
on the PC and position the device so that it is located in
a comfortable position for the user. Orient the HAND-TRAK
so that the cable faces toward the user.
-
The HAND-TRAK should immediately begin to function. If it
does not, restart the PC.
Operating Instructions
-
The HAND-TRAK is operated by simply moving a fingertip or
the palm of the hand lightly across the top of the dome.
Note that the sensing area of the HAND-TRAK is the small
(8 mm / 0.3 in) circle at the very top of the dome. No
other area on the dome is sensitive to movement except this
small circle. The HAND-TRAK model H-PTSMP-A0002 is
configured for primary use with the fingertips, as it places
the most frequently used buttons where they are within easy
reach of the fingers. This configuration is well-suited to
applications in which vibration is not an on-going problem
and allows the user to keep a fingertip on the sensing area.
For applications where the user would be unable to hold the
fingertips steady, the H-PTSMP-A0001 configuration would be
more appropriate.
-
For best operation, the user should make contact with
light pressure on the sensing area of the HAND-TRAK.
-
Gloves made of any material can be worn while operating
the HAND-TRAK as long as the area of the glove in contact
with the sensing area has texture.
-
The three large keys on the HAND-TRAK operate in the same
manner as the buttons on a standard mouse. The small,
round button located at the bottom center of the device (near
the cable exit) is pressed to enter the "Left Click and
Drag" mode. To exit the "Left Click and Drag" mode, simply
press the button again or press any of the
other three keys.
-
Operation of the HAND-TRAK may be adjusted to the user's
preference using the "Mouse Properties" control panel
provided with the computer's operating system. (As a
starting point in Windows 2000®, try setting "Speed"
to mid-range and "Acceleration" to "None.")
-
The HAND-TRAK may be used as provided on a horizontal
desktop or countertop. However, since the HAND-TRAK will
operate at any angle, it may be mounted in any position
desired by using Velcro® or double-sided tape. If
mounted vertically, make certain that the back of the
HAND-TRAK (where the cable exits) is at the
bottom of the device. Mounting drawings
may be found at:
http://www.itacsystems.com/HT/HT_specs/HT_specs_DT-ROHS.cfm .
Care Instructions
-
The small circle at the top of the HAND-TRAK dome is made
of synthetic sapphire. To operate properly, this sensing
area must be kept relatively clear. Occasionally wiping
the top of the HAND-TRAK dome with a soft, dry cloth will
keep it operating smoothly. This occasional wiping is the
only maintenance that your HAND-TRAK should need.
|